Simplicity-manufacturing I7524E User Manual download pdf (Page 11)

Intermediate Frame Snowthrowers

6/2006 11

TP 300-5196-00-IS-SN

1. Loosen the two nuts (A, Figure 21).

2. Place the shift lever (B, Figure 18) in 5th gear. The

lower speed selector rod (B, Figure 21) will properly

locate itself due to an integral spring.

3. Grasp upper speed selector rod (C, Figure 21), and

pull up, then tighten the two nuts (A) while maintain-

ing the position of the upper rod. Make sure the

shoulders of the carriage bolts are in the slots.

4. Always check traction drive tension and auger drive

tension after adjusting speed selector.

Figure 21. Drive Linkage

A. Nut C. Upper Speed

B. Lower Speed Selector Rod

Selector Rod

Speed Selector

Adjustment

If the discharge control is difficult to operate, first

lubricate the pinion gear (A, Figure 22) and ring gear (E).

The pinion gear can be adjusted by loosening the bolts

is too tight against the ring gear, move it away slightly

and then retighten the bolts. Check operation again. If

discharge control is still difficult to operate, see Chute

Direction Control Rod Gear Adjustment.

Figure 22. Discharge Control

A. Pinion Gear

B. Control Rod

C. Bolt (2)

D. Bracket

E. Ring Gear

Discharge

Control Adjustment

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

Simplicity-manufacturing I7524E User Manual Page 11